 |
Stepper Motor (High Precision)w/o Rear Shaft, 6V, 1200mNm (RS Product)This motor has 8-lead configuration allowing maximum flexibility for connection to any standard stepper motor drive boards. The windings can be connected in series or parallel for different drive requirements. Step Angle is1.8° ,which is directly compatible with the stepper motor drive boards. |
 |
Stepper Motor (High Precision)AstroSyn-My180 - 1.8°, 12V (Farnell Product)Coil Type: Unipolar / Bipolar, Current Rating: 0.6A, No. of Phases: Two, Resistance: 20ohm, Inductance: 35mH, Inertia: 110g-cm², SVHC: No SVHC (19-Dec-2011), Frame Size: 23, Holding Torque: 0.539N-m, Indexing Angle: 1.8°, Phase Resistance: 20ohm, Voltage Rating V DC: 12V. |
 |
Stepper Motor (High Precision)1.8°, 4.8Nm (RS Product)High energy Neodymium magnets used, 50% more torque than conventional hybrid types, 8 wire format provides a choice of either Uni-polar or Bi-polar operation, 200 steps/rev when used with full step drives or 400 steps/rev when used in half step mode, NEMA frame sizes. |
 |
Stepper Motor Driver BoardUnipolar, 2A (RS Product)Directly compatible with any of the RS stepper motors up to 2A, 4-phase unipolar motor drive up to 2A/ 30Vdc per phase, Full step and half step drive modes (for higher resolution, greater performance stability and faster stepping rates)External control inputs are C-MOS and open collector TTL logic compatible, Pre-set control for setting predetermined motor phase excitation pattern, On-board 12Vdc, 50mA output for external use, Drive board and the motor can share the same dc.. |
